Using Geoexplorer
When using Geoexplorer, you need to collect two kinds of data.

One is the raw data for differential correction, only for the six control points.

For example, you are standing beside the point "heat". The date is Feb. 20th.

1.Turn on Geoexplorer. It shows the main manual. wait for five minutes for caputuring the signal of satelites.

2.Use up or down  button to choose "1.Data Capture", press enter button.

3. Choose "1.Open Rov. File", press enter button.

4. wait for 10 to 20 seconds for collecting raw data. On the screen you can see the time is counted in seconds.

5. write down your file name for "heat". The name should be in this format "R0220XXX" for Feb. 20th. 

6. Press enter button after you wait more than 10 seconds.Choose "Yes" to close this file.

7. Now Geoexplorer goes back to "Open Rov. File" automatically. Don't press enter button now .

8. suppose your next point is "nail_e". Take your Geoexplorer to "nail_e" and press enter button to start 
   another new file.


The other is waypoint for your comparation and feature mapping.

1.Turn on Geoexplorer. It shows the main manual. wait for five minute for caputuring the signal of sattlites.

2.choose "4.Navigation", press enter button.

3. Choose "4.Waypoint Setup", press enter button.

4. Choose "1.Add Here", press enter button.

5. Write down your waypoint name and take some notes. For example, "W10" is one of the waypoints for 
   your polygon feature.

6.Then press enter button. Geoexplorer saves your waypoints automatically. 

7.Go to another point and do it again.


If you want to know the satellite information, 
in "Main Manu", choose "Satellite satus", then "sat. tracking".
You can know something like "PDOP" there.